TL;DR – Quick Summary
- Expert roof flashing repair and replacement in Howell Township, NJ — we fix leaks around chimneys, skylights, vents, and valleys.
- Fast, affordable repairs that prevent major water damage later on.
- Call (732) 637-8300 or schedule your flashing inspection now.
Why Roof Flashing Matters More Than You Think
Most leaks don’t start in the middle of your roof — they sneak in around edges, vents, and chimneys. That’s where the flashing lives, those thin strips of metal that seal joints and transitions. Around Howell Township, we see flashing fail often from wind, rust, or bad caulking. And when it does, water slips in behind shingles and ruins decking fast.
Keystone Roofing Siding Windows specializes in pinpoint flashing repairs. We fix leaks where others just patch shingles. Whether your home’s flashing is aluminum, copper, or galvanized steel, we make sure it’s sealed tight and watertight again.
Why Choose Keystone for Flashing Repairs
- Local roofers, local roofs: We know the common weak spots on Howell homes and fix them right the first time.
- Full flashing replacement: We remove old, corroded metal and rebuild the area cleanly.
- Compatible materials: Match your roof style and finish — asphalt, metal, tile, or slate.
- No guesswork: Moisture tracing to find the exact point of entry.
- Warranty protection: Every repair includes material and labor guarantee.
Our Roof Flashing Repair Process
- Inspection & diagnosis. We locate problem flashing areas and test for trapped moisture.
- Removal of damaged flashing. Rusted or cracked sections are carefully removed to protect shingles.
- New flashing install. Custom-fit flashing sealed with high-grade roofing cement or solder.
- Seal & finish. We reseal all joints and apply protective coating if needed.
- Final test. Water-test around repaired areas to confirm no leaks remain.
Flashing Repair Costs in Howell Township
| Flashing Type | Typical Cost* | Common Issues |
|---|
| Chimney Flashing Repair | $400 – $900 | Rust, loose mortar, gaps in counter flashing |
| Valley Flashing Replacement | $500 – $1,200 | Metal corrosion or improper overlap |
| Pipe Boot & Vent Flashing | $250 – $600 | Cracked rubber or lifted sealant |
| Skylight Flashing Reseal | $350 – $800 | Old or misaligned factory flashing |
*Costs vary by roof type, height, and accessibility.
Areas We Serve
- Ramtown – older homes with rusted chimney flashing.
- Oak Glen – vent flashing repairs after wind damage.
- Candlewood – roof valley flashing replacement during re-roofs.
Local Testimonials
“We had leaks by our chimney for months. Keystone replaced the flashing, and it’s been bone dry since.” – Jim R., Howell Township
“They showed me photos of the cracks and explained the repair step-by-step. Super transparent.” – Tara S., Candlewood
FAQs About Roof Flashing Repairs in Howell Township
- Q: How do I know if my flashing is bad?
- A: You might see water stains near chimneys or skylights, or loose metal visible from the ground.
- Q: Can you just seal over old flashing?
- A: We don’t recommend it. Sealing without replacing often hides damage temporarily.
- Q: Do you use copper flashing?
- A: Yes, we offer copper, aluminum, or galvanized steel depending on your roof’s design.
- Q: Is flashing repair covered by insurance?
- A: Sometimes, if the damage was caused by storms or wind — we’ll help you find out.
- Q: How long does flashing last?
- A: Typically 20–30 years with good maintenance and clean gutters.
Book a Flashing Inspection
Leaks around chimneys, vents, or skylights? Don’t wait. We’ll check, repair, and reseal before water spreads inside your home.
Schedule Flashing Repair
Home | Roofing Services | Roof Flashing Repairs | Contact
Keystone Roofing Siding Windows • 1029 US-9 N Howell Township, NJ 07731 • (732) 637-8300
